GE Energy Star JVE40 Manual Del Usuario página 10

REMOVE FILTERS
2
Remove the protective shipping film from the edges
of the metal grease filters. Press the filter locks back and
lift the filters out. Set them aside.
Filters
REMOVE WIRING COVER
3
FROM THE JUNCTION BOX
Remove the wiring cover from inside the hood.
Set the cover and its mounting screw aside.
Wiring
cover
Mounting
Screw
4
REMOVE WIRING KNOCKOUT
Remove either the top or the back wiring knockout as
needed and install an approved strain relief clamp.
Strain relief
clamp
10
Installation Instructions
REMOVE DUCT KNOCKOUT(S)
5
If recirculating, non-vented ductless see note below and
skip to Step 7 and proceed.
Using a flat blade screwdriver, remove the appropriate
duct knockout(s) from the top or back of the hood.
" x 10" Rectangular
3
1 4
vertical discharge.
Remove top rectangular
duct knockout only.
NOTE: If the hood is to be installed in a recirculating,
non-vented ductless manner, order charcoal filters, kit
number WB02X11000 for 30
can be ordered from your GE supplier. Skip to Step 7C and
proceed.
NOTE: If the hood is installed for recirculation mode, it is
not E S certified.
®
NERGY TAR
" x 10" Rectangular
3
1 4
horizontal discharge. Remove
rear rectangular duct
knockout only.
hood models. These kits
"
49-80622-5