GE Energy Star JVE40 Manual Del Usuario página 12

8 CHOOSE VENTING OPTION
The hood can be set to vent outside or to recirculate air
back into the kitchen.
•
To vent to the outside, refer to steps 5 and 6.
•
To recirculate air into the kitchen, remove two
screws securing the duct block off plate. Discard
plate. Replace two screws.
Note: Hood is E
NERGY
air to the outside.
FOR RECESSED-BOTTOM CABINETS
9
ONLY
Wood shims
• If the cabinets have front, side or back trim, make
2 wood shims the width of the trim and attach them to
the cabinet bottom recess on both sides. See Step 7 for
marking locations.
CUT HOLES
10
Cut holes at marked locations for duct and electrical
wiring. For the vertical duct, cut out 3/4" extra toward
the front of the cabinet so you can move the duct
freely when installing the hood. It may also ease
installation by cutting the hole 10
RUN WIRES
11
Run the electrical wires through the wall or cabinet
according to National Electrical Code and applicable
local codes.
NOTE: DO NOT turn the power on until installation is
complete.
12
Installation Instructions
S certified only when it vents
®
TAR
" instead of 10".
1 2
OPTIONAL POWER CORD KIT JXHC1
12
Use only with range hood cord-connection kits that
have been investigated and found acceptable for
use with this model range hood.
For installation with a standard 3-prong, grounded
wall outlet, Power Cord Connection Kit model
JXHC1 must be used. This kit contains a power
cord and the hardware required to connect it
to the range hood. It is available at extra cost
from your GE supplier. Follow the Installation
Instructions packed with the kit.
C L
7
3 4
NOTE: If using optional Power Cord Kit JXHC1, feed
the power cord through the hole in the top cabinet
while raising the hood. Loop any excess length of
cord and tie away with a suitable tape or tie.
13
SCREW IN PARTWAY
Drive a mounting screw (from the hardware packet)
partway into each center of the narrow neck of the
keyhole slots marked on the cabinet bottom.
14 FEED IN WIRES
Lift the hood into position and feed the house
wiring through the wiring knockout.
SECURE HOOD
15
Slide the hood back against the wall. Tighten the
mounting screws. Be sure the screw heads are in
the narrow neck of the keyhole slot.
Keyhole (4)
Cabinet
3-prong
wall outlet
(if using cord
connection)
1
1 4
1 dia. clearance hole
3 4
for optional power
supply location
49-80622-5