GE Energy Star JVE40 Manual Del Usuario página 11

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

" x 10" RECTANGLE DUCTED
FOR 3
6
1 4
DISCHARGE INSTALLATIONS:
Attach exhaust adaptor/damper over knockout
opening with two exhaust adaptor screws. Make sure
damper pivot is nearest to top/back edge of hood.
Remove tape from damper flap.
Up to 1" side-to-
side adjustment
Pivot
NOTE: The exhaust adaptor/damper can be installed
up to 1 inch on either side of the hood center to
accommodate off-center ductwork. In extreme off-center
installations, one end of the duct connector may need to
be trimmed to clear the electrical cable clamp.
49-80622-5
Installation Instructions
Tape
Top/back edge
Exhaust adaptor/damper
(vertical discharge position
shown)
MARK HOLES
7
Select the vent option that your installation will require
A. Outside top exhaust
"
(Vertical duct–3
1 4
• Use the diagram or the hood as a template and mark
the locations on the cabinet for ductwork, electrical
wiring and keyhole screw slots.
Hood mounting screws (4)
13¾"
Cabinet front
Cabinet Bottom
"
5
1 4
Vertical duct
"
access hole
3
/
11
16
Wood shims
11/16"
(recessed-bottom
Center
cabinets only)
B. Outside rear exhaust
(Horizontal duct–3
• Use the diagram or the hood as a template and mark
the locations on the cabinet for ductwork, electrical
wiring and keyhole screw slots.
Wood shims
(recessed-bottom cabinets only)
Cabinet front
Horizontal duct
3½"
access hole
"
5
1 4
13¾"
Hood mounting
screws (4)
Center line
C. Recirculating (non-vented ductless)
• Use the hood as a template and mark the locations
on the cabinet for the electrical wiring and keyhole
screw slots.
• Since the hood is to be recirculated (not to be vented
outside), do not cut out any vent openings in the wall
or cabinet bottom.
"
x 10
Rectangular)
13¾"
7¾"
"
5
1 4
1¼"
14 16
Electrical access
hole (in cabinet
bottom)
line
"
"
x 10
Rectangular)
1 4
1¼"
½"
Cabinet
bottom
"
5
1 4
7¾"
13¾"
Electrical
access hole
(in wall)
9¼"
"
11

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Jve40

Tabla de contenido