Troubleshooting; Disposal - Hilti WSR 650-A Manual De Instrucciones

9. Troubleshooting

Fault
The tool doesn't start.
The tool does not achieve
full power.
No orbital action
Saw blade cannot be
removed from the blade
clamp

10. Disposal

Most of the materials from which Hilti electric tools are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for taking
back your old electric tools for recycling. Please ask your Hilti customer service department or Hilti representa-
tive for further information.
Should you wish to return the electric tool yourself to a disposal facility for recycling, proceed as follows:
Dismantle the electric tool as far as possible without the need for special tools. Use absorbent paper to wipe oily
parts clean and to collect any grease that runs out (total quantity approx. 50 ml). This paper should also be disposed
of correctly. On no account should oil or grease be allowed to enter the waste water system or to find its way
into the ground.
The individual parts should be separated as follows:
Part / assembly
Toolbox
Gear housing
Grip
Motor housing
Fan
Motor (rotor and stator)
Gearing parts
Screws, small parts
Battery
Printed: 07.07.2013 | Doc-Nr: PUB / 5071405 / 000 / 00
Possible cause
Control switch defective.
The battery is not inserted correctly.
Low stroke rate selected
Control switch not pressed fully
The battery is discharged.
Orbital action selector switch not
set to [ ]
Locking sleeve not turned as far as
it will go
Main material
Plastic
Aluminium
Plastic
Plastic
Plastic
Steel and copper
Steel
Steel
Nickel-cadmium
Nickel-metal hydride
* Do not dispose of batteries with general refuse.
Remedy
The switch should be checked and, if neces-
sary, replaced by an electrical specialist.
Insert the battery correctly.
Set the stroke rate regulator to the setting
recommended for the material to be cut
(see section "Before use").
Press the control switch as far as it will
go.
Charge the battery.
Set the orbital action selector switch to
[ ] The orbital action can be felt only
when sawing.
Turn the locking sleeve as far as it will go
and remove the saw blade.
Recycling
Plastics recycling
Scrap metal
Plastics recycling
Plastics recycling
Plastics recycling
Scrap metal
Scrap metal
Scrap metal
*
en
9