Troubleshooting; Disposal - Hilti WSR 36‑A Manual Del Usuario

9. Troubleshooting

Fault
The power tool doesn't start.
en
The power tool doesn't achieve
full power.
The saw blade can't be
removed from the blade
holder.

10. Disposal

CAUTION
Improper disposal of the equipment may have serious consequences: The burning of plastic components
generates toxic fumes which may present a health hazard. Batteries may explode if damaged or exposed to
very high temperatures, causing poisoning, burns, acid burns or environmental pollution. Careless disposal
may permit unauthorized and improper use of the equipment. This may result in serious personal injury, injury
to third parties and pollution of the environment.
CAUTION
Dispose of defective batteries without delay. Keep them out of reach of children. Do not attempt to open or
dismantle batteries and do not dispose of them by incineration.
CAUTION
Dispose of the batteries in accordance with national regulations or return them to Hilti.
Most of the materials from which Hilti power tools or appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, Hilti has already made
arrangements for taking back your old power tools or appliances for recycling. Please ask your Hilti customer
service department or Hilti representative for further information.
26
Possible cause
The control switch is defective.
The battery is discharged or fitted
incorrectly.
The stroke rate is set too low.
The control switch is not pressed
fully.
The battery is discharged.
The locking sleeve is not turned as
far as it will go.
Remedy
Have it checked by a trained
electrical specialist and replaced if
necessary.
The battery must be heard to engage
with a double click or, respectively,
needs to be charged.
Adjust the stroke rate regulator
to a setting recommended for the
material to be cut.
Press the control switch as far as it
will go.
Change the battery and recharge the
discharged battery.
Turn the locking sleeve as far as it
will go and remove the saw blade.