BEBE CONFORT Titan Manual Del Usuario página 46

EN
ATTENTION:
•
For group 1 usage in ISOFIX use the tting clips for lower anchorage to the vehicle are not
su cient. It is essential to x the "TOP TETHER" to the upper anchorage point recommended
by the car manufacturer.
•
Fitting the Bébéconfort Titan seat with additional tethers using the vehicle's ISOFIX additional
anchorage points.
•
The ISOFIX anchors have been developed to obtain a safe and easy xation of the child safety
systems inside the car. Not all cars are equipped with these anchors although they are standard
on more recent models. Consult the attached list of cars for which the car seat can be installed
correctly (you can also consult additional updates of this list on the website www.bebeconfort.
com).
•
In forward facing position, the seat must be placed on the car rear seat or exceptionally on the
front seat in accordance with the legislation in force in the country of use (In France: in
accordance with the conditions stipulated in decree n° 91-1321 du 27-12-1991).
When installing the car seat for group 1 with ISOFIX, it is necessary to remove the headrest in
order to put the TOP TETHER through correctly.
Warning: when installing the car seat, spaces between the base of the car seat and the vehicle
seat are possible depending on the position of the anchorage points within the vehicle.
•
Replace the Bébéconfort Titan when it has been subject of violent stresses in an
accident: the safety of your child can no longer be guaranteed.
•
The user must always check that any luggage and other objects likely to cause injury to the
occupant of the car seat in the case of impact are properly secured.
•
The rigid parts and the plastic sections of a child restraint device should be positioned and
installed in such a way that they cannot, when the vehicle is being used under normal
conditions, become trapped under a moving seat or in the vehicle door.
•
Always check that no part of the seat or the harness is trapped under a seat or in the vehicle
door.
45