Klarstein 10030663 Manual Del Usuario página 26

The difference between code No 23 and 24 is the safety clasp quantity. Pull up the safety clasp carefully, turn
around and take it out from the keg; replaced it by the sealant (like code No 20 sealant) provided in the beer
cooler, attach it to the beer keg, and pierce it by cooler piercing pin.
Important: Before replacing the sealants or piercing the cooler kit, you must always follow the instructions
marked on the keg to eliminate the excess gas and ensure that the keg has rested long enough to avoid foam
coming out through the cooler piercing pin /tap faucet. And it is no need to release the gas and replace the
seal rubber if you use Heineken keg, because Heineken keg has its own CO pressure inside, and no need to
2
be provided from outer CO pressure system.
2
26