Klarstein 10030663 Manual Del Usuario página 36

Cartridge pierced probe and seal washer
Cartridge pierced probe and seal washer maybe damaged when wrong usage or other reasons,
please replace a new one.
1. Firstly, pick out the seal washer with a tiny metal stick and take out Cartridge pierced probe. Be careful
not damage other parts of regulator.
2. Install a new cartridge pierced probe in the regulator (leave the sharp end outside toward), and install the
seal washer (Show as figure 32). Don't remove other parts of regulator in the replacing process.
Regulator assembly
Warning: Remember press the seal circle with empty cartridge instead of new cartridge, or will cause
hazard.
To change beer tube
Please replace the beer tube if beer tube is damaged and cause beer leakage.
1. Loose out the tube from the connection 1, draw out the tube. Pull down the lock setting, and draw the
tube out.
2. Screw out nut at connection 2, and draw the tube out.
3. Replace a new beer tube, and install the beer tube according with reverse procedure
NOTES: Don't move other screws when processing tube replacement, otherwise, it may cause the
beer leakage or gas leakage.
Slim metal
stick
Cartridge connector Seal circle
empty CO cartridge
2
36