Rowenta GS6030 Manual De Instrucciones página 8

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ccessories
Before using an accessory, check the manufacturer recom-
mendations.
It is also recommend that you carry out a test on part of
the fabric which cannot be seen.
Crease attachment*
• Gently push the crease attachment into place on the
steam head.
• Push on the handle to open the crease
• Place the garment between the crease attachment and
steam head.
• Release the handle.
• Starting at the top of the garment, move the crease
attachment in a downwards motion.
• Once unit is unplugged and completely cooled down,
remove the crease attachment by sliding it off of the
steam head.
Fabric brush*
The fabric brush opens the weave of the fabrics for better
steam penetration.
Be sure unit is unplugged and completely cool before atta-
ching accesories.
• ttach the fabric brush to the steam head by lining up the bot-
tom of the brush with the bottom of the steam head. Gently
push the top of the brush onto the steam head until it clicks
into place.
• Gently brush the area to be steamed with the grain or nap
of the fabric.
• Remove the fabric brush once unit is unplugged and com-
pletely cool. Remove it by pressing on the release tab on
top of brush while pulling it forward.
Lint pad*
The lint pad is a separate accessory and cannot be attached
to the steam head.You can use the lint pad independently from
the steamer.
The lint pad removes hair, lint and animal fur for a professional
finish.
• To use the lint pad, slowly brush the clothing with the grain or
nap of the fabric.
• The pad can be cleaned by brushing it in the opposite direction.
* epending on the model: these accessories are specific to certain models or available as an option.
(depending on model)
attachment.
8

Publicidad

Tabla de contenido
loading

Tabla de contenido