Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
contEntS
(1) GREASE
DAMPER / DUCT
FILTER
(1) PARTS BAG** CONTAINING:
(5) #10 X 5/8"
RD. HD.
MOUNTING
SCREWS
PREPaRE tHE HooD
7
Remove all
protective polyfilm
from the hood
(stainless steel
hoods only).
8
Remove the
aluminum Filter
from the hood by
pulling the tab
down and lifting
filter out.
(4)
9
Remove 8 Screws holding Bottom Pan to hood.
Disconnect Light Harness.
10
Remove parts bag included with the hood. (Parts bag is
taped to inside of bottom pan.)
SCREWS
DAMPER /
DUCT
CONNECTOR
Remove 2 Screws holding Damper / Duct connector to
11
hood. Remove damper/duct connector from inside the hood.
* FIND INSIDE
OF HOOD
(1) 3¼" X 10"
(1) 7" ROUND
DUCT
CONNECTOR*
CONNECTOR
(1) BULB SUCTION
CUP TOOL
** FIND PARTS BAG TAPED TO
INSIDE OF BOTTOM PANEL.
(1)
PULL
ALUMINUM
DOWN
(2)
LIFT
OUT
(4)
Remove 7" Round Duct Plate from top/back of hood.
12
FoR non-DuctED InStaLLatIonS - Skip to "InStaLL
tHE HooD" .
BAFFLE
FILTER
DuctED InStaLLatIon onLY:
13
Remove Baffle from Slot above air box.
BAFFLE
14
DuctED InStaLLatIon onLY:
Rotate Baffle and insert long side into Slot above air
box. Baffle is inserted properly when you feel a positive
stop.
15 non-DuctED InStaLLatIon onLY:
Purchase a non-ducted filter (Model BPQTF) from your
local distributor or retailer. Attach the non-ducted filter fol-
lowing instructions packed with the non-ducted filter.
QML SERIES
7" ROUND
DUCT
PLATE
SLOT
SLOT
Page 4
Publicidad
Tabla de contenido
