Husqvarna T536 LiXP Manual De Instrucciones página 31

the chain saw. Always stop the motor before moving
from tree to tree.
Two factors decide whether the chain will jam or the object
that you are cutting will split: the first is how the object is
supported before and after cutting, and the second is
whether it is in tension.
In most cases you can avoid these problems by cutting in
two stages; from the top and from the bottom. You need to
support the object so that it will not trap the chain or split
during cutting.
WARNING! If the saw chain jams in the
!
cut: deactivate the machine! Do not try to
pull the machine free. If you do you may
be injured by the saw chain when the
machine suddenly brakes free. Use a
lever to open up the cut and free the
machine.
The following instructions describe how to handle the
common situations you are likely to encounter when using
a chain saw.
Cutting/bucking
The log is lying on the ground. There is little risk of the
chain jamming or the object splitting. However there is a
risk that the chain will touch the ground when you finish
the cut.
Cut all the way through the log from above. Avoid letting
the chain touch the ground as you finish the cut. Maintain
full throttle but be prepared for what might happen.
WORKING TECHNIQUES
- If it is possible (can you turn the log?) stop cutting
about 2/3 of the way through the log.
- Turn the log and finish the cut from the opposite side.
The log is supported at one end. There is a high risk
that it will split.
Start by cutting from below (about 1/3 of the way through).
- Finish by cutting from above so that the two cuts meet.
The log is supported at both ends. There is a high risk
that the chain will jam.
- Start by cutting from above (about 1/3 of the way
through).
- Finish by cutting from below so that the two cuts meet.
–
English 31