Assembly; Fitting The Bar And Chain - Husqvarna T536 LiXP Manual De Instrucciones

Ocultar thumbs Ver también para T536 LiXP:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Fitting the bar and chain

Li-ion
Li-ion
WARNING! Always remove the battery
!
before any assembly, maintenance and/
or checking is done on the machine.
WARNING! Always wear gloves, when
!
working with the chain.
Check that the chain brake is in disengaged position
by moving the front hand guard towards the front
handle.
Unscrew the bar nut and remove the drive sprocket
cover. Remove the transportation guard (A).
Fit the bar over the bar bolt. Place the bar in its
rearmost position. Place the chain over the drive
sprocket and in the groove on the bar. Begin on the
top side of the bar.
Make sure that the edges of the cutting links are
facing forward on the top edge of the bar.
Fit the drive sprocket cover and locate the chain
adjuster pin in the cut-out in the guide bar. Check that
the drive links of the saw chain fit correctly on the drive
A

ASSEMBLY

sprocket and that the saw chain is in the groove in the
guide bar. Tighten the bar nut finger-tight.
Tension the chain by turning the chain tensioning
screw clockwise using the combination spanner. See
instructions under the heading Tensioning the chain.
The chain is correctly tensioned when there is no
slack on the underside of the bar, and it can still be
turned easily by hand. Tighten the bar nut with the
combination spanner while holding up the tip of the
bar.
When fitting a new chain, the chain tension has to be
checked frequently until the chain is run-in. Check the
chain tension regularly. A correctly tensioned chain
ensures good cutting performance and long life.
English
21

Publicidad

Tabla de contenido
loading

Tabla de contenido