SEVERIN RB7028 Manual De Instrucciones página 77

Chill.book Seite 77 Dienstag, 8. Dezember 2015 3:13 15
11 Troubleshooting
Problem
The robot vac- Dust bin is too full or filter is soiled.
uums but does
Switch off the appliance (position "0") and page 71, „Cleaning and care".
not pick up any
dirt
The " " LED The dust bin is full. Empty the dust bin. chapter „Emptying the dust bin", page
lights up 71
The robot goes A cable of one of the wheels has become detached.
round and
Open the wheel cover and re-insert the cable or contact the customer service
round in circles
department page 319, „Service Centres"
The robot is The slider for setting the sensitivity of the sensors is on a setting for light floors
running but is while the appliance is being used on a dark floor.
constantly trav-
Adjust setting of the slider for the setting of the sensitivity of the sensors,
elling in re-
page 55, „Setting the drop sensors".
verse.
The robot The rechargeable battery needs to be charged.
stops on its
Switch off the appliance (position "0") and charge rechargeable battery, page
own.
57, „Charging the robot".
The robot has Help the robot manually by giving it a push.
become stuck.
The robot does It is possible that soiling is preventing one of the wheels from moving freely.
not move in
Free wheel of dirt. If necessary, carefully use a scissors or tweezers for this.
straight lines
directly after it
is switched on.
One of the It is possible that dirt is preventing this round brush from moving freely.
round brushes
Remove the round brush (page 60, „Setting up and connecting the charging
no longer
station") and free it of dirt. If necessary, carefully use a scissors or tweezers for
turns.
this.
Individual bris- Signs of wear.
tles of the
Soak the brushes in hot water.
round brushes
are bent
Possible cause / solution
77