Troubleshooting - SEVERIN RB7028 Manual De Instrucciones

Chill.book Seite 76 Dienstag, 8. Dezember 2015 3:13 15

11 Troubleshooting

Using the table below, check whether you can remedy the problem:
When a fault is shown on the display screen, the robot emits 3 sound signals, one after the other.
Fault code
E 1 Wheels or robot stuck
Switch off the robot. Free the robot from obstructions. Switch the robot back on.
E 2 Cover or dust bin not installed correctly.
Insert the cover and dust bin correctly.page 74, „Inserting the dust bin"
E 3 The bumper is stuck.
Free the robot from obstructions
E 4 The robot has been lifted for longer than 1 second.
Place robot on the floor.
E 5 Floor too dark.
Set the drop sensors correctly. page 55, „Setting the drop sensors"
E 6 Charging error. The robot has been switched off or the rechargeable battery
pack has not been installed correctly.
Insert the rechargeable battery correctly. page 56, „Inserting the rechargea-
ble battery pack"
Switch on the robot.
Problem
The robot can- The rechargeable battery has not been inserted correctly.
not be
Insert the rechargeable battery correctly. page 55, „Preparing the robot".
switched on.
Rechargeable battery is completely discharged.
Switch on the appliance (position "I") and charge the rechargeable battery.
page 57, „Charging the robot".
The remote The remote control rechargeable battery is completely discharged.
control does
Charge the remote control. page 59, „Charging the remote control"
not function
The robot and/or remote control are in strong light.
Close the curtains and switch off any string light sources.
Robot too near to the charging station.
Position the robot at least 2 metres from the charging station.
76
11 Troubleshooting
Possible cause / solution
Possible cause / solution