3M Filtrete Standard Guía De Uso Y Cuidado página 4

BEFORE YOU BEGIN:
You will need an adjustable wrench for this installation.
Remove items stored under the sink.
Have a towel and bowl available in case dripping occurs.
This system uses
push-in fittings:
This easy-to-install system uses
watertight, push-in fittings.
To Attach Tubing:
(Fig. 1)
Push tubing in as far as
it will go. Tubing must be
inserted past o-ring and
hit backstop. Pull tube to
ensure it is secure.
ATTACH WATER SUPPLY
LINE ADAPTER:
You will need: Adjustable wrench (Note: Two
wrenches may be needed to adequately tighten
fittings when connecting the adapter to the
supply line), male water supply line adapter (D)
1. Turn off the cold water supply at the shutoff
valve under the sink. (Fig. 6)
2. Disconnect the cold water faucet hose from
the shutoff valve below using a wrench.
Leave the hose attached to the faucet
above. (Fig. 7)
3. Install the male water supply line adapter (D)
placing the faucet side onto the end of the
faucet hose. Note: Fitting has a faucet side
and a push-in side. (Fig. 8)
Note: If the water supply line adapter (D)
does NOT fit properly onto the end of your
faucet hose, visit your local hardware store
to purchase the correct size.
To Release Tubing:
(Fig. 2)
Push in grey collet to
release tubing.
With collet held, pull
tubing straight out.
4
(Fig. 6)
(Fig. 7)
(Fig. 8)