Installation And Removal Of The Base - Prexiso T.O.2 Manual Del Usuario

4.5 Installation and Removal of the Base

Remove of the base
Installation of the
base
Operation Method
1. Turn the screw on knob a outward using
flat screw driver until it no more limits
position.
2. Turn knob a counter-clockwise, holding
a
the base with one hand and take the
main body of the instrument off the
base.
1. Turn the knob a counter-clockwise until
it reaches the position limit.
b
2. Make the positioning block b on the
main body of the instrument in line with
c
the notch c on the base and install the
main body onto the base as shown.
3. Turn the knob a clockwise until it
reaches the position limit so that the
mark points downward.
4. Turn the screw until it can limit position.
T.O.2 | 29