Prexiso T.O.2 Manual Del Usuario página 34

Adjustment
Inspection and Adjustment
5. If the laser point remains at the center of the cross mark, no adjustment is required;
otherwise adjust as follows.
1. Remove the protective cover of the laser
plummet and adjust the adjustment
screws of the laser plummet, using the
hexagonal wrench, so that the laser
point moves the half of the offset a
towards the cross mark.
2. Repeat the steps 2. to 5. in "Inspection"
and step 1. in "Adjustment" until the
laser point superposition.
a
T.O.2 | 32