Cleaning The Machine - Krups XP4050 Manual Del Usuario

• Machine automatically cools down when
pressing the coffee button (one or two cups)
- When cooling down, the start/stop button
blinks and hot water automatically flows
into drip tray . When correct temperature is
reached, the coffee selection buttons will
glow continously and the machine is ready
to make espresso.
. Using the perfect froth accessory as an
alternative to the auto cappuccino
accesssory.
• Replace the auto cappuccino accessory with
the perfect froth accessory.
Fill the water container with fresh, cold
•
water (1) (2) (3) and turn on the machine
(4).
• When the machine is ready (start/stop switch
glows continuously), press the steam button
(16), and the start/stop switch will begin
to blink.
When the steam button glows continuously
again, the machine is ready for steam.
Immerse the perfect froth accessory in the
•
milk to be heated (we recommend that a
stainless steel container with a capacity of
about 0,5 litres be used).(17b)
Hold the container under the perfect froth
•
accessory in such a way that the tip is
immersed in the milk.
Press the steam button
•
container steady during this operation. Do
not allow the tip of the perfect froth
accessory to touch the bottom of the
container as this will obstruct the steam
output.
• Once the desired level of froth has been
produced, press the steam button
again to stop.
Follow this cleaning operation in order to
prevent the milk from drying on the auto
cappuccino accessory:
• Submerge the perfect froth accessory in a
container with water.
• Press the steam button
the water has run through, press the steam
button again
Wipe the perfect froth accessory with a
•
damp cloth.
12
(16). Keep the
(16) and when all
(16) to stop.

Cleaning the Machine

- Never wash your espresso machine
accessories in the dishwasher.
After use, the water tank must be emptied.
. Drip tray
If several espressos are being prepared one
after the other, the drip tray should be
emptied from time to time (about once every
7 - 8 espressos) (19). The presence of water is
normal and does not signify a leak. If
necessary, clean the drip tray and its grid with
water and a little non-abrasive washing-up
liquid, rinse and dry. Replace it correctly (20).
. The brewing head, the filter and the
filter holder
These must be cleaned after each use. All you
need to do is wipe with a damp cloth over the
brewing head of your machine and to wash
the other accessories in water and a little non-
abrasive dishwashing liquid, rinse and dry.
If the brewing head is heavily clogged up,
unscrew the grid, clean it and refit it, pressing
down firmly (21).
When your espresso machine is not being
used, do not leave the filter holder on the
machine as it will cause unnecessary wear of
the gasket
. The cup warming plate: remove this to
clean it with water and a little non-abrasive
dishwashing liquid, rinse and dry.
. The auto cappuccino accessory
For more thorough cleaning the auto cappuc-
cino accessory can be dismantled from the
machine.
Clean it with water, a little non-abrasive
dishwashing liquid and a small brush. Rinse
(16)
and dry it before refitting it.
Please note the direction of fitting the flexible
tube : engage the straight-cut end in the auto
cappuccino accessory.
Descaling
Descalling is necessary to keep your espresso
machine running efficiently.
As a result descaling of your espresso
•
machine should be done fairly regularly.