Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Once you have made your crossover type selection, continue to rotate the selection knob until you reach
the frequency then the slope and make your desired adjustments. The examples below show the steps
taken to make the adjustments for High Pass (HP) operation.
Press the center of the selection knob once to enter the adjustment mode for the frequency setting. The indicator
will change to a solid arrow and you then rotate the selection knob right to increase the frequency or left to
decrease the frequency. Once your adjustments have been made, press the center of the selection knob once to
leave the adjustment mode so you can continue to the next setting. In the following example we have adjusted
the High Pass (HP) frequency to 100Hz
Rotate the adjustment knob until you
reach the frequency adjustment for
the High Pass (HP) setting
Position
Indicator
The following examples show the same steps as explained above except these selections show X-over
adjustments for "Low Pass" operation.
Position
Indicator
Crossover
Selection
Frequency
Indicator
Crossover
Selection
Frequency
Indicator
9
This example shows that we have
adjusted the High Pass slope to
24dB
Crossover
Selection
Slope
Indicator
Crossover
Selection
Slope
Indicator
Publicidad
Tabla de contenido
