NXS Mobile Audio NXLCDC Instrucciones De Instalación página 11

The following example show the same steps as explained the previous pages except all selections are
made for adjusting the X-over for "Band Pass" operation.
Position
Indicator
Position
Indicator
If you wish to turn off the X-over for full range output from the amplifier, move the position indicator in front
of "ON" and press the center of the selection knob and "OFF" will be displayed indicating the amplifier is in
full range mode (All Pass).
Selection Select HP X-Over
Indicator Frequency
Selection Select LP X-Over
Indicator Frequency
10
Selection Select HP X-over
Indicator Slope
Selection Select LP X-over
Indicator
X-over is Turned OFF
Full Range Operation
Slope