Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PRIMARY AMP
MULTI-AMP
LEVEL
ADDRESS
ADDRESS
CONTROL
ON
OFF
8 4 2 1 A SW
The amplifier's LEVEL CONTROL" switch is
set at the "ON" position to allow the "SUB
LEVEL" adjustment on the NXLCDC to
control the amplifiers output.
S
YSTEM STARTUP & SUB LEVEL
When the system is turned on, the NXLCDC powers up and starts to
search the DSP Netlink for connected devices (amplifiers). As NXLCDC
searches each of the 10 addresses on the network, the LCD display will
show the progress and how many amplifiers have been found.
After the amplifiers are found, the NXLCDC will then check to see if a
Mono Amplifier is installed or if the"LEVEL CONTROL" switch on any
amplifier in the network is turned on. If the NXLCDC finds any amplifier(s)
meeting this condition, the display screen will show "SUB LEVEL" and the
amplifier(s) output level will be controlled by the NXLCDC. All NXS Mono
Amplifiers are automatically controlled by the "SUB LEVEL" adjustment
since they are dedicated subwoofer amplifiers. If you are using a two or
four channel NXS Amplifier to power subwoofers in the system, the
"LEVEL CONTROL" switch found on the amplifier can be turned "ON"
position to allow the NXLCDC to control the output level of the amplifier.
HIGH
INPUT
LEVEL
INPUT
LEVEL
L
MIN
MAX
R
NX400.2
If no Mono Amplifiers are installed or if the level switches on all amplifiers
are turned off, the display will show "NO SUB" the SUB LEVEL control will
not operate.
5
OUTPUT
DSP NETLINK
SPEAKERS
PRIMARY AMP
MULTI-AMP
LEVEL
ADDRESS
ADDRESS
CONTROL
L
R
REMOTE
AUTO SENSING
PWR
ON
L
OFF
ON
OFF
8 4 2 1 A SW
IN
OUT
PRT
R
BRIDGED
POWER
GND
+12V
REM
FUSE
50A
Publicidad
Tabla de contenido
