NXS Mobile Audio NXLCDC Instrucciones De Instalación página 8

Selection
Indicator
When in the gain adjustment mode, the position indicator ( ) will show your location on the LCD screen.
Rotate the selection knob to each channel you wish adjust and then press the center of the adjustment
knob to select. Each selected channel will show a solid arrow ( ) indicating the selection you have made.
(If you wish to deselect a channel, press the center of the selection knob a second time.)
Position Indicator
shows your location
on the LCD screen.
This example shows
that channels 1 & 2
have been selected as
indicated with the
solid arrows.
After you have selected all channels you want adjusted, rotate the selection knob to the "OK" position and
press the center of the selection knob to activate the adjustment. The solid arrow ( ) next to "OK" will
indicate the gain in ready for adjustment by rotating the selection knob. Once your adjustments have
been made press the selection knob again to accept.
G
AIN ADJUSTMENTS
Once the amplifier selection has been loaded, rotate
1 2 the selection knob until the selection indicator points
3 4
to "GAIN" and press the center of the selection knob
PC INPUT
once to enter the gain adjustment mode.
NXLCDC
7
Selected channel(s)
are indicated by a
solid arrow.
O n c e " O K " i s
selected, the gain is
adjusted by rotating
the selection knob.