NXS Mobile Audio NXLCDC Instrucciones De Instalación página 12

S
UBSONIC & X-OVER ADJUSTMENTS (MONO AMPLIFIERS)
Selection
Indicator
When in the X-over selection mode, rotate the selection knob and the
position indicator ( ) will show your location on the LCD screen. Select
"SUB" and press the center of the control knob to advance to the X-over
adjustment screen.
There are two X-Over selections for the mono amplifiers HP & LP. The High Pass (HP) is the subsonic filter
to block unwanted frequencies below your woofers operating range to optimize the woofers performance.
The Low Pass (LP) is the crossover for the woofer(s). Rotate the selection knob and the position indicator
( ) will show your location on the LCD screen. Press the center of the adjustment knob to select the item
you want to adjust. The selected item will show a solid arrow ( ) indicating the selection you have made is
ready to adjust by rotating the selection knob. Once your adjustment is made, press the center of the
selection knob to proceed to the next item.
Position
Indicator
Once the mono amplifier selection has been loaded,
1 2 rotate the selection knob until the selection indicator
3 4
points to "X-OVER" and press the center of the selection
PC INPUT
NXLCDC knob once to enter the x-over adjustment mode.
Subsonic Filter Adjustments
"ON"
Selection Select Subsonic Filter
Indicator
11
Frequency
Selection Select Subsonic
Indicator Filter Slope