NXS Mobile Audio NXLCDC Instrucciones De Instalación página 14

Selection
Indicator
When in the EQ adjustment mode, rotate the selection knob and the position indicator will show your
location on the LCD screen. Select the *channels you wish to adjust and press the center of the control
knob to load the channels selected. Next rotate the selection knob to the item you wish adjust. Once the
position indicator is on item you wish to adjust, press the center of the selection knob to select and then
rotate the control knob to adjust.
Select the *channels you wish to
adjust and press the center of
the control knob.
Position
Indicator
Band Indicator
B1 ~ B8
*NX400.4 selections shown, LCD screen shots will look different however the overall EQ function remains the same.
E
QUALIZER ADJUSTMENTS
Once the amplifier selection has been loaded, rotate the
1 2
selection knob until the selection indicator points to "EQ"
3 4
and press the center of the selection knob once to enter
PC INPUT
NXLCDC
the EQ adjustment mode.
The EQ can be turned "OFF" or
turned back "ON" by pressing
the center of the selection knob.
All settings will be saved even in
the off position.
Position
Indicator
Selection
Indicator EQ Frequency
13
The "FLAT" adjustment will put
all EQ
when the center of the section
knob is pressed.
Adjust Selection
Indicator
levels to FLAT (0dB)
Position
Indicator
Adjust
EQ Gain Level