Iso Mount Radio Provision - Metra 99-3302 Instrucciones De Instalación

1. Mount the ISO Brackets to the radio using the
screws supplied with the radio. (Figure A)
2. Slide the radio into the housing until the side clips
engage. (Figure B)
3. Locate the factory wiring harness in the dash.
Metra recommends using the proper mating
adapter from Metra or AXXESS. Re-connect the
negative battery terminal and test the unit for
proper operation.
4 Snap the trim plate onto the front of the radio
housing. (Figure B)
5. Aura, Cobalt, G5, HHR, Sky and Vue only:
Cut and remove top mounting tabs on each side
of the Radio Housing. (Figure C)
6. Reassemble dash in reverse order
of disassembly.
Kit Assembly 99-3302

ISO mount radio provision

Note: Refer also to the instructions included with the aftermarket radio.
(Figure A)
(Figure B)
Right side clip
13
Cut top two holes off
(Figure C)