Ecco REFLEX 5590 Serie Instrucciones De Instalación Y Funcionamiento página 2

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation & Mounting:
Important! This unit is a safety device, and it must be connected
to its own separate, fused power point to assure its continued
operation should any other electrical accessory fail.
Carefully remove the Minibar and place it on a flat surface. Exam-
ine the unit for transit damage, and locate all parts. If damage is
found, or parts are missing, contact the transit company or ECCO.
Do not use damaged or broken parts.
!
Caution! When drilling into any vehicle surface, make
sure that the area is free from any electrical wires, fuel lines,
vehicle upholstery, etc. that could be damaged.
Permanent Mounting:
1. Select the desired location on a flat surface for the
Minibar to be mounted. The visibility of the flash and
ease of wiring access should be taken into
consideration in the selection of the mounting location.
2. Unscrew the lens from the base of the minibar. Use the four
holes in the corners of the base to mark the mounting hole
locations.
3. Drill the holes using a 7/32" drill size.
4. A fifth hole may be drilled for wire access.
5. Connect the power wires as shown in the wiring section
(see Figure 2).
6. Mount the minibar with M5 hardware
Vacuum Mount Installation for 5590 Series:
1.
Remove round black stickers for vacuum placement
2.
Remove lens screws, then remove lens.
3.
Unclip and remove wire harness
4.
Position vacuum magnets, place, and tighten screws.
5.
Insert pinned end of cable through the wire harness hole from the
bottom of the base. Pull at least 6 inches of slack.
6.
Turn pins crimp side up, and insert pins into connector as shown
in Figure 2.
7.
Place zip-tie 1.0" from base of the connectors shown in Figure 3.
Zip-tie must not slide on cord.
8.
Trim excess zip-tie.
9.
Clip connector to the PCA board and pull slack until zip-tie
touches base.
10. Install lens, reverse of removal.
11. Slide o-ring onto screw until it reaches head, before placing into
lens. If o-rings are damaged, replace with new ones.
920-4300-00 Rev. D
provided.
Figure 1
!
NOTE:
Operating the vehicle without the outer
lens installed on the product may result in damage
that will NOT be covered under warranty.
BLACK WIRE
PIN 1
Figure 2
Figure 3
GREEN WIRE
PIN 3
RED WIRE
PIN 2
1.0"
Page 2 of 5

Publicidad

Tabla de contenido
loading

Tabla de contenido