Ecco REFLEX 5590 Serie Instrucciones De Instalación Y Funcionamiento página 4

Important! Disable power before wiring up the Minibar.
Wiring:
The wiring for the permanent mount minibar is as shown in Figure
6. All wiring should be a minimum of 18AWG. The positive line must
have a 7.5 amp fuse, as shown. A switch may be used to control the
on/off function.
7.5A
920-4300-00 Rev. D
Figure 6
Sequence Description
1 Quad (Factory Default)
2 Quad
3 Double
4 Double
5 Fast Double
6 Fast Double
7 Slow Quad
8 Slow Quad
9 Slow Double
10 Slow Double
11 Quint-hold
12 Quint-hold
13 Burst
14 Burst
15 Quad, Alternate Side-to-Side
16 Quad, Diagonal Alternate
17 Double, Alternate Side-to-Side
18 Double, Diagonal Alternate
19 Quint-hold, Alternate Side-to-Side
20 Quint-hold, Diagonal Alternate
21 Fast Rotate
22 Rotate/Quad
23 Wave Rotate
24 Random
25 Steady
Flash Mode Selection:
Flash patterns can be selected on permanent mount minibars by
touching the yellow wire to the red power wire for less than a sec-
ond. Contacting the yellow and red wires for longer than a second
toggles to the preceding flash pattern. The 5590-VM and 5590-VM
models have flash pattern select via a momentary switch on the
cigarette plug.
Flash Pattern Syncing:
The 5590 permanent mount models sync with other compatible
ECCO products via the blue wire:
1. Determine the desired style of flash pattern for each unit and
set each unit individually (without the BLUE wires connected
together) to avoid confusion. It is also strongly recommended that
the same style of flash pattern be used on all units to produce the
most effective warning pattern. (NOTE: Phases A and B for each
style of flash pattern in the table denote the relative timing
between units connected in a synchronizing installation. To
operate simultaneously, each unit must be set to the same phase
(A + A or B + B); to operate alternately, units must be set to have
the opposite phase (A + B or B + A)).
2. Connect the BLUE (SYNC) wires together and check that the
units are flashing in a synchronized manner as expected. If a
pattern on one module appears to be wrong, the YELLOW
(PATTERN SET) wire can be used to cycle forward or backward
on that individual unit until the correct pattern is selected.
Note: This will only change the pattern in the one unit and will
not affect the other units connected to the BLUE (SYNC) wire.
3. If the blue wire is unused, leave unconnected and insulated.
Flash Pattern Chart
Phase FPM
A
75
B
A
75
B
A
130
B
A
65
B
A
65
B
A
75
B
A
75
B
150
150
150
150
150
150
120
150/75
70
5590
SAE J845 Title
class 1 13
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes
Yes
Page 4 of 5