GE AFQ08 Manual Del Propietario E Instrucciones De Instalación página 14

INSTALL THE CASE
9
IN THE WNDOW
A Carefully position the case in the window
until the bottom mounting rail drops into the
channels in the supports. Center the case and
lower the window behind the top mounting
rail. The case should be slightly tilted to the
outside. Use a level; about a 1/2 bubble will
be the correct case slant to the outside.
Top mounting rail
INSIDE
B
Attach the bottom of the case to the support
rail with 2 Type A screws, one on each side.
INSIDE
Extend the left and right accordion panels
C
to the vertical window sashes and attach
the top corners with 2 Type B screws. Use
an accordion panel clamp on each lower
corner to trap the panels. Attach them to
the stool using 2 Type B screws.
Top mounting rail
Type B
screw
Panel clamp and
Type B screw
INSIDE
NOTE: Seal any openings around the case
or accordion panels with sealer or foam
gaskets.
Installation Instructions
1/2 Bubble
Type B
screw
Panel clamp and
Type B screw
SECURE THE CASE IN THE
10
WINDOW AND INSTALL THE
FOAM TOP WINDOW GASKET
A
Attach the window locking bracket with
a Type B screw.
B
Cut the foam top window gasket to the
window width.
C Stuff the foam between the glass and the
window to prevent air and insects from
getting into the room.
14