GE AFQ08 Manual Del Propietario E Instrucciones De Instalación página 5

When the air conditioner is turned on, it will
automatically start in the setting last used,
except the timer will be cancelled if it was set.
COOL Mode
Use the COOL mode with HIGH or LOW fan for
cooling. Use the Increase v / Decrease w pads
to set the desired temperature between 60°F and
86°F in 1°F increments.
A thermostat is used to maintain the room
temperature. The compressor will cycle on and off
to keep the room at the set level of comfort. Set the
thermostat at a lower number and the indoor air
will become cooler. Set the thermostat at a higher
number and the indoor air will become warmer.
NOTE: If the air conditioner is off and is then turned on while
set to COOL, it will take approximately 3 minutes for the
compressor to start and cooling to begin.
FAN Mode
Use the FAN at HIGH or LOW to provide air
circulation and filtering without cooling.
Since fan only settings do not provide cooling,
a temperature setting will not be displayed.
Air Direction
Up and Down
Fingertip pressure on the horizontal louvers
adjusts the air direction up or down.
Lights on the air conditioner control panel indicate
the selected settings.
Cooling Descriptions
For Normal Cooling—Select the COOL mode and
HIGH or LOW fan with a middle set temperature.
For Maximum Cooling—Select the COOL mode and
HIGH fan with a lower set temperature.
For Quieter & Nighttime Cooling—Select the COOL
mode and LOW fan with a middle set temperature.
NOTE: If you switch from a COOL setting to OFF or to a fan
setting, wait at least 3 minutes before switching back to a
COOL setting.
Side-to-Side
Turn on Circulaire to provide continuous
side-to-side air circulation.
For fixed side-to-side air direction, turn on
Circulaire until the desired air direction is
obtained, then turn it off.
www.GEAppliances.com
5