Kit Preparation; Kit Assembly - Metra DP-3003 Instrucciones De Instalación

Kit Preparation

1. Place the climate control locater
template into the factory climate
control mounting holes and mark the
new locater holes in the sub-dash.
(Figure A)
2. Cut and remove the radio rear support
shelf from the dash cavity.
3. Test fit the climate controls in the
new location to verify the new locater
holes are aligned properly.
4. Secure the climate controls with (2)
#8 x 3/4" Phillips pan head screws
and washers supplied.
5. If using the included snap in pocket,
slide it into the dash panel until it clips
in. If not using the snap in pocket,
screw the blank plate to the back of
the kit using (2) #8 x 3/8" Phillips pan
head screws provided. (Figure B)
6. Using the provided (5) #8 X 3/8"
Phillips truss head screws, attach the
rubber flap removed in step 5 of dash
disassembly to the radio trim panel.
Continue to kit assembly
(Figure A)
(Figure B)
DP-3003
1. Attach the supplied panel clips to the
back of the new dash panel (oriented
the same way as the factory panel clips).
(Figure A)
2. Remove the vents and switches from the
factory dash panel, and then clip them
onto the new dash panel, in the same
locations which they were removed from.
3. Attach the radio brackets to the radio
using the screws supplied with the radio.
(Figure B)
4. Locate the factory wiring harness and
antenna connector in the dash, and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra and/
or AXXESS. Test the radio for proper
operation.
5. Slide the radio into the dash cavity until it
clips into the dash.
6. Plug all necessary connectors into the
switches installed in the new dash panel,
and then snap the panel into the dash.
3

Kit Assembly

(Figure A)
(Figure B)