Assembly Connection Piece - Extremis WALRUS Instrucciones De Montaje

ASSEMBLING THE CONNECTION PIECE
WHAT YOU NEED
2 people
no. 17 spanner
+/- 15 min.
2. Hold the base of the connector underneath, between
the 2 frames, level with the holes intended for
attaching the connector. Lay the upper plate on top of
the 2 frames, also level with the holes intended for
attaching the connector.
4. Place the seat cushions on the frames and fix them in place by attaching the Velcro straps around the glass fibre rods
(see step 6 on page 7).
1. Place the modules in the correct position in the
definitive place where you intend to use the sofa. Place
the modules side by side and align them as well as
possible.
3. Attach the base and upper plate using the nuts and
lock bolts. Tightening the nuts will bring the two
modules closer together. Tighten them until the
frames are pulled right up against the vertical ribs
of the connector base.
A
A
english
A
11