G Eneral Safety Informations; U Se Of The Machine For; Intended; I Ncorrect Use - SUHNER ROTO TT Documentación Técnica

1. N
1.1 g
eneral safety informations
This operation manual is applicable for the machine
ROTO TT. The machine may only be handled by person-
nel who are qualified. Suitable safety and hygiene meas-
ures must be taken.
It is imperative that you observe the safety instruc-
tions provided separately.
The working environment must be kept clean and
well illuminated. Keep away persons in the vicinity
when you are using the hand piece. Wear tight fit-
ting clothing and secure long hair. SUHNER does not ac-
cept any liability for changes to the delivered design, the
modification or use of parts not supplied by SUHNER, or
the use of parts not designed for this specific model, in-
cluding any changes to the operating personnel's work-
flows. Electrical components must always be installed
and serviced regularly by a qualified person. This ma-
chine requires an earthed three-core plug and must be
connected to a suitable electricity supply with controlled
earthing. Do not use this machine in stagnant water.
Very sharp blade!
Use only food grade (FDA approved) lubricants,
e.g. TURBO LUBE GREASE (Art.-Nr. 60000078),
TURBO LUBE SPRAY (Art.-Nr. 60000077). Do not
place the hand piece on a hard surface, but only in the
provided receiver.
1.2 u
se of the machine for purposes for
which it is intenDeD
This machine is designed exclusively for powering SUH-
NER TURBO TRIM hand pieces SH and SHS. Make sure
that only SUHNER flexible shafts are used.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
Declaration of conformity
Otto Suhner GmbH, Trottäcker 50, D-79701 Bad Säck-
ingen, hereby declares under sole responsibility that
the product with the serial or batch no. (see reverse
side) complies with the requirements under the Direc-
tive 2014/30/EU, 2006/42/EC. Applied standards: EN ISO
12100, EN 60335-1, EN 55014-1, EN 55014-2, EN 61000-
3-2, EN 61000-3-3. Document Agent: T. Fischer. D-Bad
Säckingen, 10/2019
T. Fischer/Division manager
20
S
oTES oN aFETy
2. c
2.1 i
nstallation instructions
2.1.1 s
uspenDing the machine
The machine has been developed
for mounting at a certain distance
from the workplace. The machine
must be sited properly if it is to operate for the best pos-
sible results and counteract abnormal postures. This re-
quires the right distance between the user and the ma-
chine.
An incorrectly mounted machine may cause premature
2.1.2 s
upply machine wich electricity
It is imperative that the mains voltage agrees with
the specifications on the ratings plate.
2.1.3 c
onnecting the flexiBle shaft
The flexible shaft must be greased before it is con-
nected. See Section 4.1.2.
Pull the sleeve down to the stop.
ommISSIoNINg
failure of the flexible
shaft or its housing.
Further consequenc-
es are premature
user fatigue and
physical discomfort.
The schematic de-
picts the correct sit-
ing.