Sideburner Troubleshooting - Weber Summit 89173 Guia Del Propietario

operatinG the handle liGht
Handle Light has a built-in "Tilt Sensor." With the power button (a)
The Weber Grill Out ™
activated, the light will come on when the grill lid is open. The light will turn off when the
lid is closed. For daytime use, deactivate the sensor by pressing power button (a).
problem
weber Grill out handle
™ Are the batteries old?
light does not light.
Are the batteries installed correctly?
Is the lid in the up position with the power button ON?
Is the Weber Grill Out
Is the Weber Grill Out
if problems cannot be corrected by using these methods, please contact the Customer service representative in your area using the contact information on our
web site. log onto www.weber.com
problem
side burner does not light.
flame is low in "hi" position.
push button ignition does not work.
if problems cannot be corrected by using these methods, please contact the Customer service representative in your area using the contact information on our
web site. log onto www.weber.com
18
troUbLEShooting
hanDLE Light troUbLEShooting
CheCK
™ Handle Light activated?
™ Handle Light positioned correctly on the handle?
.
®

SiDEbUrnEr troUbLEShooting

CheCK
Is gas supply off?
The excess flow safety device, which is part
of the barbecue to cylinder connection, may
have activated.
Is the fuel hose bent or kinked?
Does burner light with a match?
® .
Replace batteries.
See assembly illustration.
Light will activate when lid is open.
Press the power button.
Adjust position (See assembly illustration).
Turn supply on.
To reset the excess flow safety device turn all burner control knobs and the cylinder
valve off. Disconnect the regulator from the cylinder. Turn burner control knobs to
START/HI. Wait at least 1 minute. Turn burner control knobs to "OFF". Reconnect
the regulator to the cylinder. Turn cylinder valve on slowly. Refer to "Lighting
Instructions".
Straighten hose.
If match lights burner, check igniter (see Sideburner Maintenance).
Cure
Cure
a