Product Description - Klarstein 0031451 Manual Del Usuario

1 Front Grille
2 Blade Cap
3 Blade
4 Plastic Mounting Nut
5 Rear Grille
6 Motor Shaft
7 Handle
8 Motor Housing
9 Neck Screw
10 Switch Box
11 Set Screw
12 Inner Tube
13 Height Adjustment Collar
14 Outer Tube
15 Stand cover
16 Screw
Assemble of Base
Loosen the screw from the bottom of outter Pipe (14). Place inner tube pipe(12) with pipe support on stand
cover(15) and fix with the screw (16). Attach the motor with switch compartment onto the inner pipe.ensure the
switch compartment is pushed fully onto the inner pipe and secured with the screw provided.
Assemble of Blade and Grille
1. Unscrew the plastic mounting nut from the front of the motor housing by rotating it anticlockwise.
2. Position the rear grille against the front of the motor housing with the handle uppermost, ensuing that the
locating pegs on the motor housing are engaged correctly in the holes of the rear grille.
3. Tighten the Rear Grille Mounting Nut clockwise. DO NOT OVERTIGHTEN IT.
4. Push the fan blade onto the motor shaft, locating the slot at the back of the blade on the drive pin that
passes through the motor shaft.
5. Tighten the blade cap by turning it anticlockwise.
6. Position the front grille against the rear grille so that the holes in the rims that accept the small nut and bolt
are in line. Insert the bolt through the holes and screw on the nut. Do not fully tighten at the stage.
7. Push the grille retaining clips into position ensuring that they engage correctly on the rim of the grille.
8. Fully tighten the small nut and bolt that passes through the rim of the grille.
7

Product Description

Assembly