Tecfrigo ORIZONT 150 Q Instalación Y Uso página 7

6. CONTROLS
The controls of tha appliance are situated at the front,inside a protected recess. .
switch on the light inside the appliance. .
3 Thermometer :
. to read the temperature inside the appliance.
inside the appliance. By pushing once the button
which can be modified by pushing on the button
7. CHECKING CORRECT FUNCTIONING BEFORE PLACING THE FOODSTUFFS IN
MAKE SURE THAT: 1
. The plug is connected. . The refrigeration unit switch is on (green light lit up).
3 4
. The door is closed. .The internal temperature, after about one hour, is suitable for the foodstuffs be
5
stored in. . The appliance is not exposed to the direct light of the sun or high powered lamps. .
room temperature does not exceed that in which the appliance is designed to work normally, i.e. +25°C
R.H.60% (climatic class 3).
8
cm. . The foodstuffs are placed on the shelves in the right way (max 5 kgs for each shelf), in order to
ensure a good circulation fo the cool air.
8. INTERNAL CLEANING
(EVERY 15 DAYS) 1
. Switch off electricity supply. . Open the door and remove the displayed foodstuffs.
3
. Let the evaporator defrost,stopping the functioning for about 1 hour. . Wipe the internal surfaces and
the accessories of the appliance with a sponge dipped in water with a little bicarbonate of soda. Dry with
care.
9. REPLACEMENT OF INTERNAL LIGHT
1
. Switch off electricity supply
3
. Detach the fluorescent tube from the lamp holder, following the arrow direction
lamp proceeding in reverse order (see picture 6).
ORIZONT 150Q :
1.
Switch off the appliance.
the tube out of the lamp socket (I).
instructions in reverse order (see figure 6).
Our products are for internal use only – do not install outside restaurants, shops.
Operator's guide
2 Refrigeration switch:
4
"SET or P" it is possible to see the set temperature,
5
"UP" or
2
7.
The compressor ventilation grilles are free from obstruction for at least 10
2
2.
. Unscrew the screws fixing the protection lamp and remove it .
2.
Remove diffusor (G) by pushing it sideways.
5.
Replace the fluorescent tube.
7
1 Light switch:
to switch on the refrigeration system.
Thermostat:
to indicate the temperature
6
"DOWN" (see picture 5).
4
4.
Replace the new
3.
Remove lamp (H).
6.
Reassemble by following the above
I
to
UK
D
E
F
6
The
NL
P
S
DK
FIN
B
GR
4.
CZ
Take
EE
LV
LT
H
M
PL
SK
SLO