Tabla de contenido
Publicidad
3
Mount the Wall Plate
Wood stud
3-1
Locate studs
< 16 mm
(5/8 in.)
3-2
Mark the wall
3-3
Drill pilot holes
3-4
Tighten lag bolts
[01]
[05]
[04]
6902-002023 <02>
41- 61cm
(16-24 in.)
[01]
Verify the center of the stud(s) using an awl, a thin nail, or an edge to
edge stud fi nder.
CAUTION:
Avoid potential personal injuries and property
damage!
Any material covering the wall must not exceed 16 mm (5/8 in.).
Minimum wood stud size: common 2 x 4 in (nominal 1½ x 3½ in).
Level the wall plate [01] and mark the hole locations.
CAUTION:
Avoid potential injuries or property damage! Pilot
holes MUST be drilled to a depth of 75 mm (3 in.), using a 5.5 mm
(7/32 in.) diameter drill bit.
CAUTION:
Avoid potential injuries or property damage!
Improper use could reduce the holding power of the lag bolt. To
avoid potential injuries or property damage
DO NOT over-tighten the lag bolts [04].
Tighten the lag bolts [04] only until the washers [05] are
pulled fi rmly against the wall plate [01].
13 mm
(1/2 in.)
(7/32 in.)
75 mm
(3 in.)
5.5mm
7
Publicidad
Tabla de contenido
