Before Commissioning - Bresser Thermo Hygro Quadro NLX Manual De Instrucciones

13 Outdoor temperature (in
15 Temperature outdoors
17 Weather trend symbol

7 Before commissioning

NOTICE
Avoid connection faults!
In order to avoid connection problems between the devices,
the following points must be observed during commission-
ing.
1.
2.
3.
4.
5.
When changing the batteries, always remove the batteries
in both the base unit and the sensor and reinsert them in
the correct order so that the radio connection can be re-es-
tablished. If one of the two devices is operated via a mains
power connection, the power connection for this device
must also be disconnected briefly when changing the bat-
12 / 88
°C or °F) (remote sensor
2)
(in °C or °F) (remote
sensor 3)
(better, steady, worse)
Place the base unit (receiver) and sensor (transmitter)
as close together as possible.
Connect the power supply to the base unit and wait un-
til the indoor temperature is displayed.
Establish power supply for the sensor.
Set up/operate the base unit and sensor within the ef-
fective transmission range.
Make sure that the base unit and the radio sensor are
set to the same channel.
14 Humidity outdoors (in %)
(remote sensor 2)
16 Humidity outdoors (in
%) (remote sensor 3)
18 Weather forecast graph-
ics (12 hours)