Troubleshooting - Logan PRO SAW F100-2 Manual De Instrucciones

Instruction Manual
Trouble Shooting
Problem
Saw does not cut straight.
Difficult or slow cutting.
Clamp does not hold moulding securely.
Moulding lengths are not consistent.
Logan Graphic Products, Inc. ("Logan") warrants the Pro Saw - Model F100-2, to be free from defects in parts and
workmanship for a period of one year from the date of original purchase. Logan warrants that it will either repair or
replace, at its sole discretion, any necessary replacement parts found to be defective. Should the product need to be
returned to Logan for repair or replacement parts, authorization for any return must come from Logan in writing. Costs
of returning the product to Logan, including insurances, shall be borne by the purchaser. Logan shall not be liable for
any damages or losses, incidental or consequential, direct or indirect, arising from the use of this product. This war-
ranty extends only to the original purchaser and is not assignable or transferable. This warranty is in lieu of all other
9
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 Toll Free 1 800 331 6232 www.logangraphic.com
PRO SAW
Solution
Increase blade tension using saw knob tension.
Tighten both pivot screws on back of saw base equally.
Tighten down on the angle block pointer, be sure you can still move
the saw swivel from left hand 45˚ to the right hand 45˚ marks.
Make sure the moulding is securely clamped.
Make sure the saw blade is correctly installed (teeth facing away
from handle).
Replace saw blade.
Turn clamps 90˚ so that they press moulding into the base and back
of fence.
Make sure the clamp posts are tight.
Make sure fence is secure.
Clamp left hand moulding first when using the stop.
Remove any saw dust, splinters and debris from between the
moulding and fence and moulding and the stop.
Warranty
warranties, expressed or implied.
Model F100-2