Logan PRO SAW F100-2 Manual De Instrucciones página 5

Instruction Manual
Assembly Procedure Continued
B. Fence Continued
6. To attach leg, turn saw base on it's side.
7. Slide leg with screw tab attached into channel of
fence extension to the desired position (Fig. 9).
8. Tighten leg by turning leg until secure.
C. Stop
1. Slide moulding stop onto fence (Fig. 10).
2. Tighten knob to lock.
Mounting-Optional
• Mount base board to table using mounting screws
supplied. Drill 1/4" (6mm) pilot holes for bolts.
D. Handle
1. Remove screws with Phillips screw driver (Fig. 11).
2. Be sure not to lose the two nuts.
3. Replace the nuts into hexagonal recess (Fig. 12).
4. Slide handle onto end of saw and line up the bolt holes.
5. Place finger over nut recess and replace screw and
tighten fully (Fig. 13).
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 Toll Free 1 800 331 6232 www.logangraphic.com
PRO SAW
Fig. 9
Fig. 10
Fig. 11
Fig. 13
Fig. 12
Model F100-2
4