Logan PRO SAW F100-2 Manual De Instrucciones página 8

Instruction Manual
Operation
A. First Cut
1. Set angle pivot to 45˚ on right side by lifting
pivot handle and rotating angle pivot until angle
block arrow lines up with 45˚ (Fig. 20).
2. Place moulding against fence finished side up
and rabbet facing operator.
3. Slide moulding under saw blade far enough so
full 45˚ cut can be made.
4. Change clamp height by adjusting block or
screw so foot is over center of
moulding (Fig. 21). To adjust clamp, squeeze
lock plate and slide (Fig. 22). To adjust foot, turn
knob.
5. Cut moulding (Fig. 23).
• Set foot parallel to moulding and as close
to saw blade as possible.
• By making long full strokes, accuracy is
improved and cutting is easier.
• Always cut long pieces first. If mistake is
made, shorter pieces can be
salvaged.
7
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 Toll Free 1 800 331 6232 www.logangraphic.com
PRO SAW
Fig. 22
Clamp Rod
Model F100-2
Fig. 20
Fig. 21
Fig. 23