Pre Operation; Operation; Starting The Operation - Skymsen HS-98 Manual De Instrucciones

2.2 Pre Operation

Before using the appliance, all the parts that are in contact with the product being
processed must washed with water and neutral soap. (Read item 3.5 Cleaning)
Remove Nº05 ( Picture 04) and then the internal components pulling them out.
Wash the components with water and soap
When assembling the internal components of the nozzle, not to tighten the
handwheel no. 05 (Picture 03). Doing that you may avoid stucking or breaking
Make sure that the equipment is firmly in the place.

3. Operation

3.1 Starting the operation

Turn off the equipment when you wish to remove the internal grindder
components.The appliance is silent. Do not leave utensils as: knifes, hooks, or
Make sure that the assembling of the components is in the correct sequence.
The starting is made as described below:
1 – Plug the equipment in the electric power socket;
2 – Turn on the master switch number 10 (Picture 01), placed in the back part of the
Cabinet No. 11 (Picture 01);
3 – Check if the Top Cover no. 01 is closed and locked
5 – Unlock the emergency button no. 02 (Picture 01) – Press Reset No. 03 (Picture 01);
6 – Press the on switch / Turn off to the positioning "I" turning on the equipment.
7 – The machine has pulsate switch and a footswitch pedal, paralleled turned on, that can
be started one or the other turning on the gridding system in pulses.
8
IMPORTANT
internal components.
IMPORTANT
similar utensils inside the equipment.