Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Dry tonal specimens, joint sealants, mucilage glue, construction joints and plaster models.
Catalyze such adhesives as contact adhesives on bonding surfaces, activate adhesives to accelerate the
gluing process, melt away bonding points and remove or attach plastic film along plate edges.
Melt frozen steps, door locks, trunk lids, doors and water pipes. Remove frost deposits from refrigerators
Disinfection: livestock sheds may be quickly sterilized with hot air at 600 ℃ . In addition, it may be used to
effectively cope with xylophagous insects （note: this machine has a risk of fire. Wooden surfaces must
Mount the nozzle on heating tube 3：
A fallen nozzle may ignite other items. Ensure that the nozzle is fixed securely to the machine.
Touching a hot nozzle may cause severe burns. Install or replace the nozzle after the machine has completely cooled down or using the
suitable tools.
A very hot nozzle may ignite desktops. Uncooled nozzles can only be placed on heat-resistant and fireproof surfaces.
The use of an incorrect or faulty nozzle may cause local overheating and damage the machine. Only the original nozzles of the machine
specified in the table may be used.
A
•
B
•
C
•
Operation Instructions:
Power supply precautions:
The power supply voltage shall be consistent with the value given on the machine nameplate. The section of extension wire
shall be at least 2×1.5 mm
Start:
1 ） Move power switch 1 to gear I or II.
2 ） Move power switch 1 to gear I or II. Set the thermostat switch as required.
3 ） Move power switch 1 to gear I. Select the function or adjust the temperature and air flow （refer to "Settings"）.
Power off:
1 ） Move power switch 1 to the position O.
97921/97922/97923
Operations
and freezers.
not be overheated）.
•
•
•
•
•
•
2
.
中文
•
•
•
EN
DE
RU
KO
PT
A
•
•
•
•
•
JA
ES
B
C
•
•
•
•
•
•
•
•
•
15
Publicidad
Tabla de contenido
