KlipXtreme Placid KNH-250 Manual Del Usuario página 3

1. Adjustable headband
2. Cushioned ear pads with foldable design
3. Noise cancelling on/off button with LED indicator: When the ANC feature is
switched on, the indicator light glows green, so you can enjoy noise-free audio.
Turn off the ANC function when not needed to extend battery life.
4. Micro USB charging port: Insert the micro-USB cable here to recharge the battery.
5. Next track/Volume up button: Briefly press this button to increase the volume
level (when the maximum level is reached, the headset will generate a short
beep). Press and hold to play the Next track.
6. Multifunction button (On/Off, Play/Pause, Answer/End a call/Redial the last
number called/Reject a call) with Bluetooth® connection LED indicator light.
Mode
Power
Press and hold this button for about five seconds to
switch the unit on or off. A tone will be heard to confirm
the device is turned on or off.
Pairing Once powered on, the device will enter
into the pairing mode.
-Alternating blue and red LED indicates that the
headphones are ready to enter into the pairing mode.
-The LED turns solid blue when the wireless connection
has been established or during a call.
-The blue LED blinks once every 4 seconds while
streaming music via Bluetooth® .
Function
Mode
Hands-free mode
Briefly press to answer and end an incoming call
Press twice to redial the last number called (on
supported devices)
Press and hold to reject or ignore an incoming call
Playback mode Briefly press to play and pause media
Note: Depending on the specifications of the connected Bluetooth
above and controls on the Bluetooth device may not be supported. Please refer to the
®
instructions in your mobile phone for further information. Also, some functions and tones will
vary depending on the mobile phone used.
7. Previous track/Volume down button: Briefly press this button to decrease the
volume level. Press and hold to play the Previous track.
8.3.5mm input jack: Use this port for wired playback. When the supplied auxiliary
cable is connected, the Bluetooth® mode is disabled automatically. The unit can
work in Aux. mode even though the battery has no charge or if the device has
been powered off. You must turn on the unit again after removing the stereo
cable from the headphones.
9. Built-in microphone: For hands-free calling.
Function
device, the functions detailed
®