Pioneer AVIC-D3 Manual De Instalación página 13

Extension lead (for speed signal)
Note:
Cords for this navigation system and those for other
products may be different colors even if they have
the same function. When connecting this navigation
system to another product, refer to the supplied
manuals of both products and connect cords that
have the same function.
Violet/white (REVERSEGEAR SIGNAL INPUT)
This is connected so that the navigation system can
detect whether the vehicle is moving forwards or
backwards. Connect the violet/white lead to the
lead whose voltage changes when the reverse gear
is engaged. Unless connected, the sensor may not
detect your vehicle travelling forward/backward
properly, and thus the position of your vehicle
detected by the sensor may be misaligned from the
actual position.
Note:
When you use the ND-PG1 speed pulse
generator (sold separately), please make sure
to connect this lead.
When you use a rear view camera, please
make sure to connect this lead. Otherwise you
cannot switch to rear view camera picture.
See Page 15.
Be sure to use only the supplied extension lead. Use of another lead
could cause fire, smoke and/or damage this navigation system.
5 m
Extension lead
5 m
(for reverse signal)
Check the position of your vehicle's
reversing lamp (the one that lights
up when the gearstick is in reverse
[R]) and find the reversing lamp lead
in the boot.
The navigation unit
Power cord
For information on other leads
See Page 9.
Connection method
Clamp the reversing lamp lead.
Clamp firmly with
needle-nosed pliers.
Fuse resistor
10
Reversing
lamp lead
12