Publicidad
22
Lubricate roof snaps on Back Gable (M) 8 places. Raise the Left Roof Panel (N) onto the back left side of the shed assembly, the arrows on the roof panel should face the
inside of the shed and point towards the Ridge Beam (R).
Using (2) step stools (1 inside shed, 1 outside shed), lift bottom of the roof panel above horizontal, guide the roof panel into the Ridge Beam (R), align the back Gable (M) rib
with the channel in Left Roof Panel (N), engage Left Roof Panel (N) in Ridge Beam (R) by lowering the bottom of the roof panel onto the shed assembly (hold Ridge Beam
(R) to prevent twisting). DO NOT SNAP ROOF DOWN.
1
R
3
2
N
N
R
R
M
Channel
Roof Panel
Gable Rib
Rib
23
Install Roof Connectors (T) 4 places. You may need to lift the bottom of the roof panels to avoid the 2" x 6".
N
N
N
N
T
1
Publicidad
