Rain Bird ESP-LX Modular Instrucciones De Montaje página 3

3. Once all necessary sweep elbows are properly
positioned, pour the concrete and allow it to cure.
4. Using the included positioning template (Figure
2) to ensure proper alignment, drive four redhead
anchor bolts (included) into the concrete base.
5. Using the included washers and nuts, mount the
pedestal over the four anchor bolts and tighten
all four nuts securely (Figure 3). Ensure that the
pedestal is properly vertically aligned; shim with
redwood or treated wood spacers if necessary.
Mounting the LX Modular Controller and
Cabinet to the Pedestal:
1. Remove the knockouts from the bottom of the cabi-
net as needed to match the controller knockouts.
2. Using the included mounting screws, attach the
cabinet to the pedestal. Ensure that the position
and direction of the screws is correct as detailed in
Figure 4.
3. Permanently remove the plastic outer door from the
LX Modular controller.
4. To facilitate ease of installation, we recommend
temporarily removing the LX Modular front panel.
To do so, grasp the crescent-shaped finger hold on
the top right of the controller. Open the front panel
to approximately 90 degrees and gently remove
the ribbon cable connector from its socket in the
front panel, being careful not to bend the socket
pins while doing so. Push the front panel up, rotate
the bottom of the panel out of the housing, and
separate the front panel from the housing.
5. Attach the receptacle end of the included ground
wire to the ground tab just above the controller
transformer.
ESP-LX Modular Pedestal and Controller Cabinet - Mounting Instructions
Pedestal Mounting Instructions (LXMMPED + LXMM)
(4x) ¼"-20 nut
(4x) ¼" lock washer
(4x) ¼" at washer
Figure 3
Above diagram depicts (4x) ¼"-20 x 0.5"
Phillips hex washer head machine screw for
painted metal versions of pedestal/enclosure.
For stainless steel versions, (4x) ¼"-20 x 0.5"
Phillips pan head machine screw. For
stainless steel versions screw in from top
enclosure, opposite of above diagram.
Figure 4
C A
U T
I O N
C A
U T
I O N
3