dirna Bergstrom bycool green line SLIM FIT Manual De Instrucciones página 14

SLIM FIT
EN
A
Equipment does not start.
When connecting the power wire of
the unit, it makes intermittent beeps.
(WARNING: DO NOT TOUCH ANY
KEY OF THE CONTROL PANEL
B
OR THE REMOTE CONTROL,
OTHERWISE ELECTRONICS
WILL SUFFER IRREVERSIBLE
DAMAGES).
C
The symbol
Equipment does not respond to
D
remote control.
E
One compressor or both does/do not.
F
E0 is flashing on display.
G
Electro does not work.
H
Blower does not work.
Symptom
appears on display.
• Fuse is blown.
• Power cable is disconnected or cut.
• Power wiring is inverted.
• Connectors tape is inverted.
• Battery is low.
• Bad contact in connections (battery or
power terminals).
• Controls are not programmed anymore.
• Controls battery is flat, led is not turned on.
• Electronic control is broken down.
• Faulty controls.
• Bad connection of terminals.
• Faulty control module(s).
• Broken down compressor(s).
• Too much pressure in circuit due
to excessive charge or very high
temperature.
• Bad contact of probe cables or terminals.
• Broken down probe.
• Blocked or broken down electro.
• Fuse is blown.
• Electronic control is broken down.
• Terminals are disconnected.
• Failure in electronic control.
• Blower is faulty or its terminals are
disconnected.
14
Air conditioning for vehicles
Cause