Tabla de contenido
Publicidad
1.
Prepare the Site
2x6 Backing Material
Matériau de renfort 2x6
Material de refuerzo de 2x6
NOTICE: To properly secure the vanity, the top of the required 2x6 backing material
must be 32-3/4" (83.2 cm) from the finished floor.
Measure and mark 32-3/4" (83.2 cm) up from the floor. This will be the height
from the floor to the top of the 2x6 backing material.
Ensure there are no obstructions in the wall (such as wiring or plumbing) from
the marked height down to the floor. If there are obstructions, select another area
within the site to install the vanity.
NOTE: Extend the backing material beyond the width of the vanity to the nearest
stud. This will ensure proper support for the vanity.
Front-notch the studs 1-1/2" (3.8 cm) to ensure the 2x6 backing material is flush
against the studs.
Secure the 2x6 backing material to the studs with framing nails.
Rough-in the water supply and drain lines into the rough-in plumbing area of the
vanity.
NOTICE: To avoid the risk of product damage, the finished wall must be straight and
plumb. If the finished wall is not straight and plumb, the vanity will not be properly
supported.
Complete the finished wall. Make sure the finished wall is straight and plumb,
and the floor is flat and perpendicular to the finished wall.
Préparer le site
NOTICE: Pour bien fixer le meuble de toilette, le dessus du matériau de renfort 2x6
requis doit se trouver à 32-3/4" (83,2 cm) du plancher fini.
Mesurer et marquer 32-3/4" (83,2 cm) vers le haut à partir du sol. Ceci sera la
hauteur entre le plancher et le dessus du matériau de renfort 2x6.
S'assurer qu'il n'y ait pas d'obstructions dans le mur (telles que câblage ou
plomberie) à partir de la hauteur marquée vers le sol. Si il y a des obstructions,
sélectionner une autre zone sur le site pour installer le meuble.
1146261-2-B
32-3/4" (83.2 cm)
4
Kohler Co.
Publicidad
Tabla de contenido
