Tabla de contenido
Publicidad
E N G L I S H
Please read the following instructions before using your new Andis
trimmer. Give it the care that a fine precision built instrument
deserves and it will give you years of service.
IMPORTANT SAFEGUARDS
When using an electrical appliance, basic precautions should
always be followed, including the following: Read all
instructions before using the Andis trimmer.
DANGER:
To reduce the risk of electric shock:
1. Do not reach for an appliance that has fallen into water.
Unplug immediately.
2. Do not use while bathing or in a shower.
3. Do not place or store appliance where it can fall or be pulled
into a tub or sink. Do not place in or drop into water or
other liquid.
4. Always unplug this appliance from the electrical outlet
immediately after using.
5. Unplug this appliance before cleaning, removing or
assembling parts.
WARNING:
To reduce the risk of burns, fire,
electric shock, or injury to persons:
1. An appliance should never be left unattended when plugged in.
2. Close supervision is necessary when this appliance is used by,
on or near children or individuals with certain disabilities.
3. Use this appliance only for its intended use as described in
this manual. Do not use attachments not recommended by
Andis.
4. Never operate this appliance if it has a damaged cord or
plug, if it is not working properly, if it has been dropped or
damaged, or dropped into water. Return the appliance to an
Andis authorized service station for examination and repair.
5. Keep the cord away from heated surfaces.
2
6. Never drop or insert any object into any opening.
7. Do not use outdoors or operate where aerosol (spray) products
are being used or where oxygen is being administered.
8. Do not use this appliance with a damaged or broken blade or
comb, as injury to the skin may occur.
9. To disconnect turn control to "off" then remove plug from outlet.
SAVE THESE INSTRUCTIONS
THIS PRODUCT INTENDED FOR PROFESSIONAL USE
OPERATING INSTRUCTIONS
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is
wider than the other). This plug will fit in a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician to install the proper outlet. Do not change the plug in any way.
Plug cord into electrical outlet, operate at 120 volt, 60 cycle AC electrical current or as
noted on the unit. To start trimmer, move ON/OFF switch button to ON position, to
stop, move switch button back to original position.
ATTACHING THE TRIMMER COMBS
(Some models do not have combs and sizes will vary by kit)
To attach trimmer combs, slide front of comb over the teeth of the blade (Figure A).
Snap comb down over back of blade until comb snaps into place (Figure B). Combs
help guide hair to cutting blades and give you precise control of hair lengths. Each
comb allows a different length of cut which is indicated on the combs. Use the chart
on the next page to find the approximate lengths of cut. Different blade angles in
relation to the skin, thickness and texture of the hair will vary the cutting length.
REPLACEMENT (REMOVAL) OF BLADE SET
To remove the blades, first unplug the trimmer from the electrical outlet. Turn the
trimmer upside down, so that the blade teeth are pointing down. You may want to
place the trimmer on a flat surface to do this. Unscrew the screws on the blade
(Figure C). Remove the blade. To replace the blade, put the blade back into position
while aligning the yoke of the blade with the pivot arm of the trimmer. (Figure D). Line
up the screw holes in the bottom blade with the two holes in the trimmer housing,
and replace screws. Do not over tighten screws.
3
Publicidad
Tabla de contenido
