Tabla de contenido
Publicidad
A
B
D
BLADES
PIVOT ARM
YOKE
BOTTOM
BLADE
BLADE SCREWS
TRIMMING GUIDE
Description
Standard Andis Blade
1/16" Blade Attachment
#0
1/8" Blade Attachment
#1
1/4" Blade Attachment
#2
3/8" Blade Attachment
#3
1/2" Blade Attachment
#4
4
C
E
F
Approximate
Clipping Direction
Length of Cut
With hair grain
1/16" (1.6 mm)
Against hair grain
1/32" (0.8 mm)
With hair grain
3/16" (4.8 mm)
Against hair grain
3/32" (2.4 mm)
With hair grain
1/4" (6.4 mm)
Against hair grain
1/8" (3.2 mm)
With hair grain
3/8" (9.5 mm)
Against hair grain
1/4" (6.4 mm)
With hair grain
1/2" (12.7 mm)
Against hair grain
3/8" (9.5 mm)
With hair grain
5/8" (15.9 mm)
Against hair grain
1/2" (12.7 mm)
USER MAINTENANCE
The internal mechanism of your trimmer has been permanently lubricated by the
factory. Other than the recommended maintenance described in this manual, no other
maintenance should be performed, except by Andis Company, or an Andis authorized
service station. To find an Andis authorized service station near you log on to
www.andis.com or contact our customer service department: 1-800-558-9441.
CARE AND SERVICING OF YOUR ANDIS TRIMMER BLADES
Blades should be oiled before, during, and after each use. If your trimmer blades
leave streaks or slow down, it's a sure sign blades need oil. The trimmer should be
held in the position shown in Figure E to prevent oil from getting into the motor. Place
a few drops of Andis Clipper Oil on the front and side of the cutter blades (Figure F).
Wipe excess oil off blades with a soft dry cloth. Spray lubricants contain insufficient oil
OIL
for good lubrication, but are an excellent clipper blade coolant. Always replace broken
or nicked blades to prevent injury. You can clean the excess hair from your blades by
using a small brush or worn out toothbrush. To clean the blades we suggest to
immerse the blades only into a shallow pan of Andis Blade Care Plus, while the
trimmer is running. Any excess hair and dirt that has accumulated between the blades
should come out. After cleaning, turn your trimmer off and dry blades with a soft, dry
cloth and start clipping again.
BLADE & TRIMMER REPAIR SERVICE
When the blades of your Andis trimmer become dull after repeated use, it is advised
to purchase a new set of blades available through your Andis supplier. Some blade
sets can be resharpened – contact your Andis supplier or the Andis Company for
information on resharpening. If you wish your trimmer to be serviced as well, contact
your Andis supplier. If you have a problem contacting your Andis supplier, contact
the Andis Company customer service department at 1-800-558-9441 or email at
info@andisco.com.
CAUTION: Never handle your Andis trimmer while you are operating a water faucet,
and never hold your trimmer under a water faucet or in water. There is danger of
electrical shock and damage to your trimmer. Andis Company will not be
responsible in case of injury due to this carelessness.
5
Publicidad
Tabla de contenido
